POE20U-560G Phihong 19.6W High Power Single Port Power over Ethernet Injector - 1000pc Minimum Special Order

Specifications:

• AC Input Voltage Range - 90 to 264V AC
• AC Input Voltage Rating - 100 to 240V AC
• AC Input Current - 0.75A (RMS) maximum for 90V AC, 0.45A (RMS) maximum for 240V AC
• Leakage Current - 1.0mA maximum at 254V AC, 50Hz
• AC Input Frequency - 47 to 63Hz
• AC Inrush Current - 15A (RMS) maximum for 115V AC, 20A (RMS) maximum for 230V AC
• Total Output Power - 19.6W at 56V DC
• Efficiency - 65% at maximum load, and 120V AC 60Hz
• Hold-up Time - 16mS minimum at 120V AC and maximum load
• Transient O/P Voltage Protection - 60V maximum at switch on/off at any AC line phase
• Temperature - Operation 0 to +40°C
• Non-Operation -25 to +65°C - Humidity 10 to 90%
• EMC - FCC Part 15 Class B, EN55022 Class B
• Isolation Test - Primary to Secondary: 4242V DC for 1 minute 10mA, Primary to Field Ground: 2121V DC for 1 minute, Output to Field Ground: 2121V DC
• Immunity - ESD: EN61000-4-2 Level 3, RS: EN61000-4-3 Level 2, EFT: EN61000-4-4 Level 2, Surge EN61000-4-5 Level 3, CS: EN61000-4-6 Level 2,Voltage Dips EN61000-4-11, Harmonic: EN61000-3-2 Class A
• Insulation Resistance - Primary to Secondary: >10M OHM 500V DC, Primary to Field Ground: >10M OHM 500V DC
• Over Voltage/Current, Short Circuit Protection - Outputs equipped with short circuit protection and overload protection as per 802.3af specifications The output can be shorted permanently without damage.
• Indicators - Green LED 1: Input power “ON”, Red LED: Fault detected, Green LED 2: Valid IEEE802.3af load detected and connected
• Input Connector - IEC320 inlet 3 pin

POE20U-560G Specifications PDF